"Keep ‘em in the 10 ring"
Where shooters, collectors and enthusiasts congregate

Please keep our troops in your thoughts and prayers.

The M14 Rifle Association The M14 Rifle Association section at M14BR.com
Click Left above for M14RA website - click right above for M14RA Shooting Events

Home of the M14 Rifle Association Discussion Forum
Our Premier Sponsors
Hawk's M14 Dummy Kits HueyGunner's Gunsmithingl LRB Arms of Long Island smithenterprise.com buladefense.com
 
Our Sponsors
M14.ca The M14 Rifle Association Dwight's Gunleather
Thanks Thanks:  2
Likes Likes:  0
Results 1 to 4 of 4
  1. #1
    Squad Leader
    Join Date
    May 2014
    Location
    Huntsville, AL
    Rounds Down Range
    305
    Post Thanks / Like

    1903A3 stock reinforcement bolts question

    I'm getting ready to re-stock my Remmy 03A3 from it's straight stock to a C stock from Sarco. The problem is that the new wood will not come with any hardware, to include the two stock reinforcing bolts. They look straight-forward in their install but I was wondering if anyone had any tips or tricks, or anything to beware of for when I go to install them? I'm assuming they get tapped into place and the nuts get tightened down and that's it. Please correct me if I am wrong. Thanks
    It's not the years... it's the mileage.
    Garand Collectors Association Member


    Winning Red Team Member - 2014 Fall Postal Shoot

  2. Thanks 4570govt, VanHahner thanked for this post
  3. #2
    FNG
    Join Date
    Apr 2022
    Location
    Texas
    Rounds Down Range
    1
    Post Thanks / Like

    Re: 1903A3 stock reinforcement bolts question

    J Petrutis,
    Did you ever get a reply on this? I've got the exact issue.
    thanks
    Dan

  4. #3
    Machine Gunner
    Join Date
    Jun 2020
    Location
    Ct
    Rounds Down Range
    115
    Post Thanks / Like

    Re: 1903A3 stock reinforcement bolts question

    Quite a while back I had a stock that needed the bolts installed also. I originally took them from a broken stock but the nuts are staked so they don't loosen. At least mine were. Best to get new replacement cross bolts and nuts if possible.

    As far as fit goes they should be semi snug but not too tough to push thru the hole in the wood. If too tough it may splinter on the backside, where the nut gets installed.

    IIRC I used a 5/16ths screwdriver and ground out some of the middle of the blade to a depth so as to engage the screw head to tighten. I believe the nuts are serrated and will get drawn into the wood without spinning while being tightened. Again, it's been awhile, memory isn't what it used to be.

  5. #4
    Sgt Major JEFFJP_N_JJ's Avatar
    Join Date
    Jun 2020
    Location
    California; USA?
    Rounds Down Range
    3,009
    Post Thanks / Like

    Re: 1903A3 stock reinforcement bolts question

    What!?
    "In a time of drastic change, it is the learners who will inherit the future. The learned usually find themselves equipped to live in a world that no longer exists." - Eric Hoffer

    "Whenever you fall... Pick something up." - Oswald Every
    Lifetime member NRA
    GOA Member

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •