January under 6 club !

[LDO6490]

Hi Guys just got back in from work but took the .45ACP and shot 60rds on my 'under 6' targets. Shot all reloads and had two powders marked wrong on some targets! Anything marked N320 was loaded up with titegroup! I use N320 now for my .357...

For LDO6490 here are the groups I shot today:



#1) 9 1/4"/WW244
#2) 8 7/8"/WW244
#3) 5 7/8"/titegroup
#4) 7 3/4"/titegroup
#5) 4" /titegroup *FINALLY!
#6) 10 1/8"/titegroup (not picture worthy)

Did notice today that the titegroup powder seems a bit cleaner than WW244 too

The bottom target is very nice. Well done.

[LDO6490]

Take the picture with your phone rotated 90 degrees. Afterward go to edit in your photo library and rotate the picture back to vertical. Now when you post here the picture it will be rightside up.

Thank you!!! It works and problem solved for me!!!

[blkgunlvr]

Well I've been trying to get some SWC target loads produced for the last three days. Dusted off the Dillon Square Deal B and loaded up the last of my close to +P Powerbond plated round nose over 8gr of True Blue. Reset the powder charge to 7grs and bullet seat for Lasercast 200gr SWCs. Dumped out the fired brass bucket, deprimed and wet tumbled 1300 pieces of 45 ACP brass. Shot my first test rounds Friday with my Springfield Range Officer @ 6-1/8. Scrunched out some more today and shot another 6-1/8 and then shot the 5-1/4 with a Jeff scoring dilemma on the mystery tenth round. After squinting and peering from every direction, I can only assume that there are five rounds in that group down at 6 o'clock on the eight ring. I sure do like the clean paper-punch holes the SWC makes!

[blkgunlvr]

OBTW- I uploaded these photos from iCloud instead of the usual emailing from my iPhone and the damn things are rotated horizontal as taken! I just can't get a break on this crap!

[Sustinemus]

That's what iApple products do.

[GunnyG]

Yuh gotta get Apple out of the picture.

[4570govt]

Looks like good shooting to me, Jeff and blkgunlvr!

[blkgunlvr]

These new 45 SWC loads look to have promise. I was having some chambering issues in the 1911 with the "shoulder" of the bullet just above the case mouth. I've deepened the seating, but now have priming issues with the Square Deal B. In the meantime, I was able to shoot a 5-1/8 round just before dark with the longer reloads in my S&W 625.

[JEFFJP_N_JJ]

I have had me some chambering issues as well with my .45's blackgunlvr... I just reset my seating die to 1.240 with my Acme 200's and now they are hanging up as you describe!

Love that 625! Wish I had one...

[4570govt]

Good shooting and fine looking 625, blgunlvr! I've owned a couple of 625's in the past, fine revolvers.